Tuesday, June 7, 2016

Father's Day

Somewhere  in the world, Father's Day is looming! In New Zealand, Father's Day is celebrated in September, so this is an early Father's Day reminder.

The Printable Craft Shop has some wonderful cutting files for those of you who own an electronic cutting machine. There are also cutting options for those who do not have a cutting machine, so everyone is covered here. Today, I have chosen to showcase the Fathers Day insert cutting file, available here. This cutting file is the inside of the card, which is great because it will allow you to make your own design for the outside of the card.

For the front of my card, I chose papers from a CTMH collection called Pathfinding. I designed and cut the lettering in Cricut Design Space and with my Cricut Explore.



The cutting file is the inner part of the card and I sized it to approximately 5.5 inches wide.

I then brought in a rectangle for the base card and sized that so the inner fitted with about 1/4 inch around all sides. I included a fold line on the base card and centred it.

In the cutting file that you download, the fold lines are made with small cuts. Because the card I was using is not too heavy, I decided to change the fold lines to scored instead of cut, which actually resulted in a better card as there were no perforations on the end result.


To finish off the card, I added some bronze Stickles to the Dad in the centre of the card and stamped an image on the bottom part of the card.

The cutting files available from the Printable Craft Shop are really good and I do recommend them. To get the best results though, I would definitely change the perforated fold lines to scored lines instead of cut lines as it does give a much better finish to the card.

Do check out the other posts from the talented Design Team.

1 comment:

Rae said...

Janet - love the card you made with my pop up cutting file. I also change the lines to score when I make up cards - but not all customers know how to use if I set them to score - so very glad that you made a point of this. I will try to make a video to show people how to do this. Problem is it would be different with each machine/software, so have to think about that. Rae